Once you have the boot in place, tighten the clamp enough to where it is snug.
Descargar Lavadora Bluesky Blf 10098199964 Manual I HaveBluesky BLF 1060X user manual I have the above washing machine and desperately need a user manual.Instruction for bluesky blf1009 washing machine.Answers SOURCE: A lot of concerns have been raised about door bellows molding, mildewing, andor ripping and needing replaced.A replacement bellow isnt cheap (prices vary, but are around 75-80), so hopefully these helpful steps will eliminate the need to call a repair service and pay the additional labor charges. New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is found in a retail store, unless the item is handmade or was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. Unplug the washer. Remove the washer top panel by removing the three torx-type screws (or 7mm) where it attaches in the rear of the washer. Remove the operator console by removing the dispenser and the scew(s) behind it. Take a putty knife and insert it under the console seam right above the door. If you push in slightly while pulling outwards the panel pops off. You can leave the wires attached and simply lay the console across the top of the washer out of the way. It is located behind the rubber seam where it attaches to the door frame. Follow this hoop around to the bottom of the door opening and locate the wire tension spring. Gently pry this spring apart and pull the wire hoop from the groove. Pull the rubber boot from the frame and push it inside towards the wash tub. You will also have to remove the door boot from the fill tube on the left hand side of the door opening. Remove the three screws that hold the door latch assembly in place. You can leave the latch in place as long as you remove the screws and push it inside slightly to remove it from the front casing of the washer. Remove the door by removing the screws holding the hinges in place. They can bend. Set the door aside in a location where it will not get stepped on or broken. There are 3 screws under the bottom edge holding it in place. Remove the front washer casing by removing the four remaining screws that are holding it in place. Remove the old door boot by locating the large clamp that attaches it to the wash tub. There should be instructions that come with the door boot with guide marks to ensure you align it correctly.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |